ã€Pump News Asia】 Pipeline pump is pressurized pipeline to solve the pipeline pressure is too low and developed a new pump, with high efficiency, power consumption, compact structure, small size, light weight, easy decoration and so on. Although the instrument is good, but also pay attention to maintenance, effective maintenance can prevent the occurrence of instrument failure, but also can effectively extend the life of the instrument. The following is a small series to share with you the pipeline pump installation and maintenance and model significance, I hope everyone will be helpful. Pipeline pump installation and maintenance and model significance Pipeline pump installation: 1, the pump should be carefully checked before installation and use of models and specifications are applicable, and said that read the product manual. 2, the pump must be carefully checked before installation and use of all parts of the fastener loose, if loose must be re-tightened. 3, the installation of piping can not be directly supported in the import and export of the pump flange, you must set up another support point to prevent damage to the pump deformation. 4, the installation of the pump above the liquid level (within the pump suction allowable range), the end of the suction pipe should be installed at the end of the valve, and set in the discharge pipe irrigation screw and valve for pre-irrigation pump Use. 5, the inlet diameter of the pump should be installed with the same suction pipe, pump outlet pipe installed with the import level, the best valve, easy to operate when the first open the valve, shut down after the first valve. 6, the pump should pay attention to the installation and use of the pump flow and head must press the manual standard, such as less than the standard head, should be installed at the pump outlet to control the flow of the ball valve, so as not to overload the motor burn. Pipeline pump maintenance and repair: 1, the use of a period of time, the machine seal surface leakage is caused by mechanical seal face wear, should be adjusted ring, screw loose stainless steel semi-circular two screws, move the ring forward properly, No Yin is better. 2, the daily boot 8-16 hours for the best use of the pump, 24 hours of continuous use should be equipped with spare parts, regular maintenance replacement, the replacement period is generally two to three months, due to be overhaul, does not affect Production or non-continuous operation can be used at any time overhaul. 3, the pump maintenance methods: a. Clear the pump housing, pump cover, impeller impurities inside and outside the dirt, washed carefully cleaned after inspection, no damage can continue to use. b. Clear and scour seal inside and outside the combination of dirt, impurities, check the sealed end surface wear, wear or scratch smaller available fine metallographic sandpaper on the flat grinding to smooth after no trace can continue to use, after grinding can not Remove the scar must be replaced. Model significance Further reading: industry leaders IFAT China Guangzhou Exhibition building water pump manufacturers ranking article belongs to Internet industry (Xiamen) Co., Ltd. All are welcome to reprint, please indicate the source and author of: Asian pumps Network Editor: gogoing (QQ / wechat: 181817456) starting: http://beng.liuti.cn/ (service hotline: 400-6030-811)
