High viscosity rotor pump in daily use focus on routine maintenance work in accordance with certain problems and principles of good control, to fully demonstrate the control and production, get a good way to maintain and extend the service life. High viscosity rotor pump has good performance, to meet the needs of different industries, in daily use focus on day-to-day work, high-viscosity pump should pay attention to matters: high-viscosity pump often fat, electric drum pump for high-speed operation , The grease is easy to volatilize, so must keep the lubricating of the bearing clean, and pay attention to change. High-viscosity pump often check and repair, electric drum pump should always check, repair, to check the power cord: the internal wiring, plugs, switches are good, the insulation resistance is normal, the tailstock is loose, commutator and brush contact Good, armature-level expansion stator winding is a moderate phenomenon, the bearing and rotating parts are damaged and so on. High Viscosity Rotor Pump CAUTION Insulation resistance, long term stand-by or electric pump for use in humid environments, must be measured with a 500-volt megohmmeter to measure the insulation resistance of the winding before use. If the insulation resistance between the winding and the motor housing is less than 7 megohms, the winding must be dried. High viscosity pump in daily use, pay attention to save The electric pump should be placed in dry, clean and non-corrosive gas environment. Save each part and exchange the same parts, the demolition of high-viscosity rotor pump, you should save each part, pay special attention to flameproof parts explosion-proof surface can not damage the hairline, including insulation pads and casing, if any Damaged, you must replace the same new parts, shall not use less than the performance of alternative raw materials or parts of the original specifications do not match, all parts should be assembled according to the original location, can not be omitted. In recent years, surface coating technology in China's equipment maintenance has been widely used for a variety of materials, parts and equipment repair. Its working principle is to add molybdenum disulfide, metal powder, ceramic powder and fiber and other special filler adhesive, directly applied to the surface of materials or parts, so that it has a wear-resistant, corrosion and other functions, mainly for surface strengthening and repair . Its process is simple, convenient and flexible, safe and reliable, does not require specialized equipment, just a good glue coated on the surface of the cleaned parts to be cured after curing can often operate at room temperature, will not make the parts Produce thermal equivalent effect and deformation. Although the viscosity of the viscous rotor pump coating process is relatively simple, but the actual construction requirements are quite strict, just choose a good adhesive, may not be able to get high viscosity strength. It is necessary to select the right adhesive, but also strictly in accordance with the correct process of adhesive coating the right adhesive, but also strictly in accordance with the correct process method line viscosity coating in order to obtain a satisfactory coating effect.
